Roots Blower

Roots Blower

Send Inquiry

Roots Blower

Established in the year 1975, we, PPI Pumps Pvt. Ltd is one of the reckoned manufacturers and exporters of Roots Blower. Under the strict guidance of our skilled manpower, we manufacture these blowers in compliance with industrial standards using sophisticated techniques. Suitable to use in effluent treatment plant, cement and process industries, these blowers are popular in the market for their sturdy structure, impeccable strength and corrosion resistant surface. We duly check Roots Blower before supplying to clients.

Working Principle
Roots Blower is unit of positive displacement, whose pumping limit is dictated by size, working rate as well as pressure conditions. It utilizes double impellers attached on parallel shafts, pivoting in inverse way in an enclosing at the side plates’ ends. As the impellers turn, air is withdrawn into single casing side and constrained out of the inverse side from the pressures that exist. The distinction pressure matured, accordingly, relies on the impedance of the associated system. Our roots blowers do not create pressure in encasing yet the release force relies on the back pressure and system resistance. Successful compressor sealing inlet range from the release region is attained by application of little functional clearance, removing the requirement of any inner lobes greasing. A couple of precisely machined composite steel, ground timing and solidified gears keep up clearances among the impellers, amid revolution. The air, supplied is completely free against oil. The lobe compressor-pumping limit, working at consistent pace stays moderately free of discharge and inlet pressure changes. Our blowers are steady volume rigs that convey a settled release against the system reverse force. It is, thusly, fundamental to guarantee that least pipeline limitations, at the discharge and inlet, are forced. Satisfactory size funneling and substantial radius bends guarantee least losses of line ensuing in greater productivity and additionally, least energy utilization. Sudden variation in cross section of pipeline ought to be evaded. To modify limit, it is essential either to modify speed (power sparing) or vent a portion of the air in environment (not power sparing). The air should not be re-circled against the release to pull as it might ensue in lube blower over-heating. No endeavor ought to ever be done to regulate the compressor limit through throttle valves in the admission or release tubing. This expands the energy load on the engine and may genuinely harm the compressor. There is an expansion in the release air temperature because of thermal compression


Technical Specifications:

Suction Capacity
100 to 8000 M3/Hr.
Discharge Pressure
1 kg/cm2 (G)